EUROLOGIC MAN-FC2000-RAID Guía de usuario descargar pdf (Pagina 61)

Installing and Removing a Power Supply

The power supplies are located in the rear of the

enclosure. Follow these procedures to install and remove the

power supplies.

Installing a Power

Supply

1 Select the power supply slot into which the power supply is to be

inserted and remove the carrier blank if there is one installed.

2 Orient the power supply, such that the LEDs are on the bottom

(on the right hand side for rack mount systems).

3 Gently slide the power supply into the empty power supply slot.

4 Secure in place using the two fixing screws (torque setting

0.3Nm).

5 Install the power cable into the AC Connector.

Removing a Power

Supply

1 Turn off the power supply using the switch located on the power

supply unit, and remove the power cable.

2 Loosen the two fixing screws.

3 Using the power supply handle, gently slide it out of the

enclosure.

CAUTION: Immediately replace the power supply carrier or

install a power supply carrier blank to maintain correct airflow.

Figure 5-3 Power Supply

Handle

On/Off

Switch

Inlet

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 89 90

Sin comentarios

EUROLOGIC MAN-FC2000-RAID Guía de usuario Pagina 61