EUROLOGIC MAN-FC2000-RAID Guía de usuario descargar pdf (Pagina 57)

Installing and Removing a Disk Drive Carrier

The disk drive carriers are located in the front of the

enclosure. Follow these procedures to install and remove the

disk drive carrier.

Installing a Disk

Drive Carrier

1 Select the disk drive slot into which the disk drive carrier is to be

installed and remove the carrier blank if there is one installed.

2 Orient the disk drive carrier such that the LEDs are on the top

(on the left for desk side systems).

3 With the cam lever fully open slide the carrier into the slot until

the lever starts to close.

4 Fully close the cam lever. The lever is fully closed, and the drive

locked in place, when the lever “clicks” into position.

Removing a Disk

Drive Carrier

1 Using your finger, release the locking tab by pressing it in the

direction shown in Figure 5-1, and pull the cam lever towards

you.

2 Fully open the cam lever. (approx. 90

to enclosure).

3 With the cam lever open wait for at least one minute to allow the

disk drive to spin down fully before removing it.

4 Gently, pull the disk drive carrier out of the enclosure.

CAUTION: Immediately replace the disk drive carrier or install a

disk drive carrier blank to maintain correct airflow.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Sin comentarios

EUROLOGIC MAN-FC2000-RAID Guía de usuario Pagina 57